Alientech car configurator KESS3 (Master)

The KESS3 has been designed to provide a quick and easy interface to any engine control unit and automatic transmission on the market, from young engine enthusiasts to the most specialized mechatronics technicians.

KESS3 combines 3 operating modes in one tool - OBD, bench and boot mode.

- OBD mode - Easily access all ECU data through the diagnostic socket.

- BENCH mode is a simple interface for logging in and you have full access to your ECU data.

- BOOT mode - This mode allows access to all areas of system data. Read, write and clone.

Configure KESS3 to suit your needs and your work. Regardless of your level and experience, KESS3 gives you the best experience in engine programming.

Suitcase set:

USB cable required to interface with KESS3 via PC

A new generation OBD cable that integrates all the communication lines used by various car manufacturers, so this cable replaces the various cables used by KESSv2. Specifically, it can also communicate with Honda, Volvo, Lotus and Toyota without any additional adapters.

1400SWALIM power supply capable of supplying sufficient current and voltage to communicate stably and securely with electronic control units.

144300TALI cable for powering the device using a BENCH power supply (sold separately)

144300KBNC cable for connection to control units using BENCH mode.

144300KTER kit with all cables required for connection in BENCH or BOOT mode.

144300T104 ribbon cable IDC 26-10, consisting of 10 wires. Used to connect directly to the control unit board.

144300T105 ribbon cable IDC 26-16, consisting of 16 wires. Used to connect directly to the control unit board.

144300T106 ribbon cable IDC 26-26 consisting of 26 wires. Used to connect directly to the control unit board.